Whirlpool ADG 644 IX

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool ADG 644 IX

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 6, 2016 at 6:46 pm #87232
    rsmith2271
    Participant

    Whirlpool adg 644 ix led is constantly flashing. There a pause after 16 flashes and then it starts again. I have tried to reset but dishwasher goes into drain mode and then stops after 60 seconds. The fault codes do not list constant or 16 flashes, so don’t what the fault could be. I have checked the NTC sensor, the power switch, door switch, the two pumps and they seem to be working correctly. Any ideas?

    January 6, 2016 at 9:01 pm #434275
    electrofix
    Moderator

    Re: Whirlpool ADG 644 IX

    think i had this some years ago where the fault was not listed. turned out to be broken wires in the door

    Dave

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.