- This topic has 4 replies, 2 voices, and was last updated 10 years, 1 month ago by
.
-
Posts
-
Have encountered a problem with a neff induction hob T44M80N0/01 when turned on display flashes straight bars or zeros no fault code appears and hob will not work.
has anyone else had a similar experience with one of these? is there a reset sequence or other method to rectify the fault.
Cheers
Auldyn ElectricsRe: Neff Induction Hob
I’d check to make sure that there isn’t a child lock set on it first. The brief flashing red lines immediately after switch on are normal.
Re: Neff Induction Hob
Checked for that no child lock on heat value 1-9 can be programmed into each hob but display constantly flashes and no hob will activate it’s as if the led control power supply is failing “cycling” as soon as it switches on.
Re: Neff Induction Hob
So you set a temp setting on a zone eg 9 on rear left and the 9 flashes. What happens if you put a saucepan on it ? Does the hob go dead , the 9 stop flashing or just not register the pan?
Re: Neff Induction Hob
Hi
pan is not registered display remains exactly the same flashing zeros then changing into dashes until it fades away.
I have replaced a couple of capacitors on the coil driver boards that were starting to bulge but that made no difference it would appear that the display board has been corrupted god knows how much that is to replace!! I don’t seem to be able to find one anywhere to price it.
- You must be logged in to reply to this topic.