- This topic has 3 replies, 3 voices, and was last updated 9 years, 12 months ago by
.
-
Posts
-
Was called out to this dishwasher with a ‘no power’ fault. On inspection found main pcb blown to bits. Traced cause to dispenser leaking rinse aid over reed switch connections and door loom. Cut reed switch plug off & insulated cables, repaired damaged loom & fitted new pcb. On switching on , display lights up all characters but buttons unresponsive. Does anyone know if there is a set up procedure for this pcb? -no paperwork with new one. Have had a look at the small display pcb and there is no apparent damage. Thanks in advance, Wiz.
Re: beko dw686 pcb/module
my experience has always been that a new pcb fits and runs without any additional proceedure.
Re: beko dw686 pcb/module
No setup procedure, should work once fitted… Would be advisable to fit both p.c.bs together.
- You must be logged in to reply to this topic.