Zan error E41 or E51?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zan error E41 or E51?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 19, 2016 at 11:47 am #88157
    iadom
    Moderator

    Model AWF1221W.

    Diagnostics flash the END light five times and the START light once but this one flash of the START light coincides exactly with the last flash of the END light.

    So is the E41 or E51??

    Tried a new doorlock to no avail.

    April 19, 2016 at 6:29 pm #437164
    electrofix
    Moderator

    Re: Zan error E41 or E51?

    51 I would say

    motor traic short

    look for earth fault on motor can be carbon dust

    Dave

    April 19, 2016 at 6:39 pm #437165
    iadom
    Moderator

    Re: Zan error E41 or E51?

    It is a bit confusing, the door lock I tried wasn’t the exact one for this model but same contacts, none of the stages of the diagnostics would actually run and as locking the door is the first step it is making me lean towards that.

    Motor is a clean as a whistle, very lightly used machine TBH.

    I am going to get the correct door lock and keep my fingers crossed. 🙂

    April 19, 2016 at 6:50 pm #437166
    electrofix
    Moderator

    Re: Zan error E41 or E51?

    I have stripped the lock a few times. cleaned and reversed the heater disk and it normally works. have made a follow up visit and changed it as if it went pop it would take out the board

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.