neff s4431b0gb/12 problem

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › neff s4431b0gb/12 problem

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 3, 2005 at 1:25 pm #8822
    admin
    Keymaster

    hi all

    i aquired a(secondhand) neff s4432b0gb/12 after plumbing it in myself,

    trying the “eco” program on it all went well !! washed the pots..

    next i tryed the “normal” program, ran the program for about 1hour all finished so i thought!. opened the door , the dishes were not washed! and the soap powder was in the bottom of the washer..

    i then tryed the “intesive” wash… same fault as the normal wash

    i then tryed the “eco” wash again and that works fine!!


    http://www.bshappliancecare.com/Neff/neffspares.html
    i think its the switch? (264514) 27.73 GBP

    any ideas?

    April 3, 2005 at 1:31 pm #130655
    it77uk
    Participant

    Re: neff s4431b0gb/12 problem

    that was me that posted the above …. just didnt log-in! doh!


    update :-

    tryed the “eco” program again and thats a no go now as well

    ok tryed again and its still a no go…. so any ideas?

    April 3, 2005 at 10:31 pm #130656
    Penguin45
    Participant

    Re: neff s4431b0gb/12 problem

    Check whether the dishwasher is heating. The machine is a Bosch appliance in disguise, the “Eco” wash will equate to the the “Quick” wash and run against time as opposed to temperature. Normally the programme would “hold” for the heat sequence, but not on that particular one.

    Regards,
    Penguin45.

    April 4, 2005 at 7:08 am #130657
    Martin
    Participant

    Re: neff s4431b0gb/12 problem

    Insufficient water in the machine is the likely cause of this one. The water inlet pressure system and hose to tub need stripping out and cleaning :tup:

    Simple job for an expert. 😉 Click on link below for help :-

    Repairs@

    Martin

    April 4, 2005 at 4:35 pm #130658
    it77uk
    Participant

    Re: neff s4431b0gb/12 problem

    hi,

    i live in ln4, nearest repairs@ is 80 miles away….

    Insufficient water in the machine is the likely cause of this one. The water inlet pressure system and hose to tub need stripping out and cleaning

    when you say easy job… im a car mechanic

    can you tell me what Bosch appliance is simular so i can see if i can find a (haines) manual.. looked on the net for a neff 1, unable to find 1, have e-mailed neff.. no reply as yet, (did that on saturday though)
    ive took the two tork screws of the lower front panel.. and i can see the pipes carnt see on how/what else to remove to get at it ! any tips/diagrams on how to remove the water inlet pressure system and hose to tub… would be greatfull

    (not bothered if i break it cause i got it for free)

    1 more thing i forgot to mention.. is there is a combi boiler 2 meters further away ( feeds the washer, then the dishwasher then the combie in that order) in the same pipe this wouldn’t be causing the problem would it)
    and thats been going ok….

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.