- This topic has 11 replies, 5 voices, and was last updated 9 years, 11 months ago by
.
-
Posts
-
Hi all, seems to be a few e01 codes, door, motor triac pcb, any ideas? I can’t even clear code .thanks
Re: Hoover dyn9164 e01 fault
The door interlock usually is the only reason for E01 to show. Have you changed the lock?
Re: Hoover dyn9164 e01 fault
Hi Deltra
Then the door will be required as a complete unit.
This has cured the ones we’ve had under warranty and out of warranty. Don’t ask as we cannot work out why.
Bryan
Re: Hoover dyn9164 e01 fault
r600a wrote:Then the door will be required as a complete unit.
This has cured the ones we’ve had under warranty
Interesting. So to prove the door is required presumably all you need do is trip the interlock with the door open, and the code clears?
Re: Hoover dyn9164 e01 fault
Interesting. So to prove the door is required presumably all you need do is trip the interlock with the door open, and the code clears?
No. We change both the door and interlock as we have changed the interlock previously and had to order the door so we kill it on first visit.
Bryan
Re: Hoover dyn9164 e01 fault
Is there not any way of clearing fault before I order a door? Must admit ,it does seem a bit odd!
Re: Hoover dyn9164 e01 fault
Hi
The fault clears itself when switched on and senses door closed. It will hold the fault on the core board until cleared using a mem reader. If you have one.We have then as we do a lot of HVR work under warranty and its easier and faster to get a clear idea of the actual faults.
Bryan
- You must be logged in to reply to this topic.