- This topic has 2 replies, 2 voices, and was last updated 9 years, 10 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
hi been to a dryer tcym750c6puk to fit a belt c00116358 1991h8.. I did fit a pattern belt from connect but can’t believe how tight it was.. had to release motor and pulley and drop drum a bit.. I’ve fitted lots of belts to earlier condensers and usually just prise on with driver.. anyways any tips and is it just me getting weaker.. cheers
Re: hotpoint dryer
I use pulley as a lever. only put in the rear bolt of the pulley but leave it loose enough so it will flip over towards the drum. put the belt around and then pull the pulley back and hook it into position. put the other bolt in and your away
Dave
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.