- This topic has 0 replies, 1 voice, and was last updated 9 years, 10 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
hi folks, I have had a wee issue with a WDD 960 showing F10 at the spin cycle, all the lights flash and the drier starts up, but it has 240v at both heater terminals with the fan on. the machine worked fine for the 4 cycles I had tried it on then this starts, it fills to the right level and the pressure tube and chamber are clear. Am I looking at PCB as the the forums are not agreeing on pressure switch V PCB.
cheers Johnnyboy
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.