- This topic has 5 replies, 5 voices, and was last updated 9 years, 10 months ago by
.
-
Posts
-
Hi all,
I’m sure i am missing something daft on this…
The dishwasher drains, fills up and starts washing for just under a minute then the motor pauses, starts up again then pauses and after about ten minutes the Wash, Rinse and End lights all flash.
I have replaced the pressure switch, cleared all three spray arms and checked the heater relay. The water circulates okay and the turbidity sensor is clean, i can’t find any loose connections on the pcb or damage 😕
Help!
RayRe: Miele G4100 57/100799235 Dishwasher
I have found the wrapping from certain detergent tabs to get caught up in the wash impellor so the machine thinks it is low on water. You have to remove the motor assembly, then you can clear the impellor.
Re: Miele G4100 57/100799235 Dishwasher
That’s most likely problem. If the filter isn’t locked down all the crap gets through!
Re: Miele G4100 57/100799235 Dishwasher
Kentish has hit the nail on the head. come across a few miele dishwashers with this problem
Re: Miele G4100 57/100799235 Dishwasher
You were all absolutely right, it was quite a few wrappers etc buried in the impellor.
All done and dusted, Many thanks! 😀Re: Miele G4100 57/100799235 Dishwasher
Miele do a little tool to turn the motor. Part No. 5585740. Sometimes it can clear the blockage without taking everything apart. I made one out of a small fork but cutting off the middle prongs and doing a bit of filing! Here is a you tube link. https://www.youtube.com/watch?v=_oQwa-0lQk4.
- You must be logged in to reply to this topic.