- This topic has 2 replies, 2 voices, and was last updated 9 years, 7 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Siemens vented Dryer, stops after 5 minutes and lights flash.
Suspect sensor 600157 or NTC 613753 on the front.
Could I have fitted a hotpoint NTC to see if it worked ?
Airflow is low but assume it’s normal for Siemens because there
Are no blockages.Re: Siemens Dryer cuts out 5 minutes
On Bosch and Siemens vented dryers the vent hose has to be 600mm before a bend and airflow is key on these the ntc is located behind the bottom left plastic cover so it’s easy to check,hope this helps kai
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.