Zanussi ZWD1262 Taco error?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWD1262 Taco error?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 2, 2016 at 1:24 pm #89742
    subs
    Participant

    Prod 91460320500
    This washer dryer was said by the customer (tenant/ letting agent job) to not be completing the cycle. The dryer element was as usual found to be low insulation as well as the wash heater. I replaced the wash heater and disconnected the dryer element as they did not use it anyway. Got called back to say still not completing cycle. When test program is run it shows e52 which is no taco feed back. Now this machine washed and spins fine. And completed a quick wash while I was there. Taco, brushes, motor, wires. connections on board all checked ok as well as valves etc. No faults found. Left it with customer to try again but anyone have ideas in meantime?

    Thanks

    Subs

    November 2, 2016 at 3:50 pm #442365
    Martin
    Participant

    Re: Zanussi ZWD1262 Taco error?

    We you say it is not completing the cycle, what state is in? Is it full of water or drained? Does the tenant know at what stage it stopped? Was it on a rinse hold program?

    I wouldn’t give much credence to the error code by the way as any spurious earth leakage could flag it up, even the motor itself.

    (I hate tacos by the way, yucky Mexican food 😈 )

    November 3, 2016 at 6:35 pm #442366
    codlets
    Participant

    Re: Zanussi ZWD1262 Taco error?

    Had this a few times in the past on various zanussi models when I used to refurb them, replacing the motor was the only solution.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.