Blown Bosch module

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Blown Bosch module

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • November 6, 2016 at 10:02 am #89773
    kaibart
    Moderator

    Hi all just after a bit of advice on what would have caused this module to go. Have done a insulation test and comes back fine but I know if I just fit new module it will go again thanks in advance for any help

    November 6, 2016 at 11:09 am #442479
    Martin
    Participant

    Re: Blown Bosch module

    You did’nt give us the ENr number of the machine. 😕

    But anyway a triac has blown so all you need do it trace the wiring to the component the triac switches to find the offender. Then replace BOTH.! Ouch! Pricey I should’nt wonder. 😮

    November 27, 2016 at 3:54 pm #442480
    kaibart
    Moderator

    Re: Blown Bosch module

    Wae28468gb/17 fd 8903 700527 have changed module and pump which caused power module to fail but I have nothing on the display have power to the main pcb,faulty display board?? Maybe any help welcome

    November 27, 2016 at 6:56 pm #442481
    Martin
    Participant

    Re: Blown Bosch module

    kaibart wrote:faulty display board??

    Can’t rule it out at this point but I have to ask if you saw it working earlier? If so then obviously it’s a connection issue so I’m sure you checked that already. So maybe the pump blew both out? Odd but hey, it’s a Bosch! 😉

    I guess because of the display issue you weren’t able to configure the module?

    November 27, 2016 at 9:48 pm #442482
    kaibart
    Moderator

    Re: Blown Bosch module

    No I couldn’t configure the power module are the Bosch display modules interchangeable as I tried another complete facia and power board without the motor plug connected and I had the start light come on and the door lock clunking

    November 28, 2016 at 8:11 am #442483
    Martin
    Participant

    Re: Blown Bosch module

    Display modules aren’t interchangeable as far as I am aware. It sounds to me as though possibly you’ve got a bunch of scrap Bosch’s and you’re trying to make one good one out of four bad ones? :rotfl:

    November 28, 2016 at 9:10 pm #442484
    kaibart
    Moderator

    Re: Blown Bosch module

    That’s what my mate from hotpoint says to me when I ask him to programme modules and they don’t programme up lol

    November 29, 2016 at 8:02 am #442485
    Martin
    Participant

    Re: Blown Bosch module

    kaibart wrote:That’s what my mate from hotpoint says to me

    A great sense of humour is essential if you work for Hotpoint, you couldn’t stick the job otherwise. Those that leave often change career and become traffic wardens.

    December 9, 2016 at 1:44 pm #442486
    kaibart
    Moderator

    Re: Blown Bosch module

    Got machine working 2nd hand facia panel with a wae24363 touch button display board and hay presto machine works fine so you can just plug in any display board just to confirm it’s gone, this is not something I would do for a customer it’s for a re con lol

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.