- This topic has 4 replies, 2 voices, and was last updated 9 years, 5 months ago by
.
-
Posts
-
I have a Bosch WTA2000 and it blew the RCD after running for 30mins or so. After removing the back panel, I noticed the bracket connecting the bearing to the drum had worn out where the rivets hold it in place. I can’t see a replacement part in the store, although I suspect it might need a new drum as the bracket is riveted to the drum.
Any suggestions before I order a new dryer?Re: WTA2000 3 Drum Rivets worn bracket
This is the repair kit you need : –
https://shop.ukwhitegoods.co.uk/4213092 … earing-kitRe: WTA2000 3 Drum Rivets worn bracket
Thanks, I saw that Martin but that doesn’t help with the riveted bracket which is the issue with my dryer. Did you look a the pictures? You can see the hole the rivet grasps is worn and widened.
Re: WTA2000 3 Drum Rivets worn bracket
I didn’t look closely at your photos to be honest otherwise I would have realised the problem, sorry. But there is a solution in the form of BKT64, a pattern bearing unit that fits in circumstances when the drum spider support rivets give way. Not shown in the spares store on this website sadly but I enclose a link to another, though the part (if still available?) is a bit on the pricey side. 😕
- You must be logged in to reply to this topic.