- This topic has 4 replies, 4 voices, and was last updated 20 years, 12 months ago by
.
-
Posts
-
I fixed this machine today 😀 It was dead, the lights came on but no-one was home. Took the lid off and gave the module a kicking…nothing 🙁 Then gave the control panel a smacking hit the start button and it burst into life 😀
Went about my way fixing another machine in this vast utility room, when I noticed the dryer had stopped, gave it a thump, hit the start button and it reset itself back onto a full cotton setting, maximum time. :con:
10 mins later, did it again, 15 mins after that it finished drying the load perfectly. So my question to all you Bosch techno-whizz kids is?????….Is it the £122 Module thats playing silly bu**ers or what? or should I sell this very rich lady a new machine??? FD number by the way is 8006 so its only 4+ years old….very sad!
Martin
Re: Bosch WTL5500GB/01 T/dryer
Have you tried it on a timed program?.
If so does it work ok?.
Had a similar problem a few months back.Cuts out after a few minutes use on sensor program,but works fine on 30 min timed prog.
Turned out to be worn carbon pick up on rear bearing part no. 154177.
Hope this helps. :tup:
Re: Bosch WTL5500GB/01 T/dryer
Hi Martin
Try removing fascia, and switch cleaning selector contacts.
Possible condenstation egressing upwards by faulty front bearing seal.Greg
- You must be logged in to reply to this topic.