Beko oven fan motor

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #90067
    clockworkone
    Participant

    Odf21300b (7731686332) I need a main oven fan motor for this double oven. Existing failed motor is the one with the tray or shroud around the back of the motor. Spares supplier quoting part no 264440102 (without shroud) as a replacement. The shaft on new one is way too long.

    #443461
    electrofix
    Moderator

    Re: Beko oven fan motor

    part number is correct

    have sent you the strip down info

    it shows early motor but later on shows later motor fitting

    may help worth a try

    Dave

    #443462
    Lawrence
    Participant

    Re: Beko oven fan motor

    If you do get it to fit then remove the earth tag from the back otherwise the protruding screw buzzes on the rear panel

    #443463
    clockworkone
    Participant

    Re: Beko oven fan motor

    Thank you both for your helpful replies. Even though that part no is listed everywhere as the correct one for this oven, it is not. Found another similar motor(300180380) with shorter shaft in my van. The only thing I had to do was put 1 washer on each of the three legs. Thanks again.

    #443464
    electrofix
    Moderator

    Re: Beko oven fan motor

    looking at the picture of the oven rear it seems to have 2 sets of holes. 1 set is recessed and the other is not. could this be an answer the newer motor goes on the other set of holes ?

    Dave

    #443465
    clockworkone
    Participant

    Re: Beko oven fan motor

    Hi Dave.Original motor fitted to non recessed holes. On new part no the shaft is a lot longer. Back plate would clash with fan.

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.