- This topic has 0 replies, 1 voice, and was last updated 9 years, 4 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi, bit of a long story but here goes.
Dishwasher wasn’t heating checked flow through heater and is was blown so fitted a new one. Started machine and error code E4(flood) came on. Switched off machine and drained water. Due to me thinking I am perfect and fitted the part correctly, I assumed the flood error was from standing the machine up after it being laid down for too long, so I started it again. E4 came on again, but this time tripped the main breaker in my consumer unit, so I drained it and had a look. The new jubilee clip I put on was leaking so I refitted it, reset the breaker and started it again. The machine powers on, but I can not select any programs.
Any ideas as to what is wrong would be very appreciated.
Cheers John
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.