Whirlpool 3RLEQ8033SW

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool 3RLEQ8033SW

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 12, 2016 at 4:54 pm #90101
    Toni
    Participant

    Hi

    I went to look at this one today as not heating
    I don’t normally get involved in these but this is an old customer

    Apparently Whirlpool have been to this and changed all the thermostats and heater (They have left all the old parts there) anThey seem to have given up on this

    Is there any thermal fuse or TOC that I may have missed ?

    Thanks
    Toni

    December 12, 2016 at 5:19 pm #443708
    electrofix
    Moderator

    Re: Whirlpool 3RLEQ8033SW

    I would still check all the stats are ok

    2 stats on the heater just like hotpoint 1 keeps temp other trips and stays out

    2 stats on the exhaust same as above

    heater wire also goes through motor so no heat until motor starts

    last is the timer switch

    part diags see http://www.maytag.com/manuals/

    Dave

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.