bosch washer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosch washer

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • January 30, 2017 at 9:21 am #90468
    dopper
    Participant

    old bosch washer carbons right down, new ones fitted working away after fitting, then she says clothes coming out a bit wet, so put it on spin think it was 11 mins did a few spins then got to 8 mins and jumped to 1 min so missed the fast spin out, no earth faults on it, will it be the board?
    Dop

    January 30, 2017 at 10:29 am #444904
    Martin
    Participant

    Re: bosch washer

    You didn’t give us that all important ENr number. Many Bosch machines only do a short spin (800rpm) on ‘spin only’ cycle.

    January 30, 2017 at 12:33 pm #444905
    dopper
    Participant

    Re: bosch washer

    sorry dont have it, but tried it on the fast spin only and it goes to 1 min after 8 mins

    January 31, 2017 at 12:47 pm #444906
    Alanj
    Participant

    Re: bosch washer

    Unbalanced load, were there clothes in the drum? Sometimes if you run the spin without a load, it will jump to 1 minute.

    January 31, 2017 at 6:50 pm #444907
    nomadPaul
    Participant

    Re: bosch washer

    Seen it a few times where worn carbons damage the board and it aborts as it reaches approx 1000rpm (it does vary) What happens if you put it on a lower spin speed?

    February 3, 2017 at 11:43 am #444908
    dopper
    Participant

    Re: bosch washer

    hi carbons were right down, only tried on fast spin, was thinking its done damage to the board

    February 3, 2017 at 11:49 am #444909
    dopper
    Participant

    Re: bosch washer

    its the same with load in and empty

    February 3, 2017 at 12:11 pm #444910
    Martin
    Participant

    Re: bosch washer

    Still no model number then Dop? It would help. 😕

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.