Bosch no fault codes displayed

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Bosch no fault codes displayed

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 2, 2017 at 7:41 pm #90496
    robti
    Participant

    Hi so my Bosch Exxcel 1400 express brushes have finally gone ( only took them about11-12 years 😮 ) So do I order a genuine set or go after market at around a third of the price ?

    Thanks

    Robert

    February 2, 2017 at 7:47 pm #444991
    admin
    Keymaster

    Re: Carbon brushes genuine or copy

    Hi

    If they have just gone then put genuine ones back in. That way you have a better chance that they will last longer and at the end of the day split the cost of the genuine ones over 10yrs and it works out at pence’s a year.

    Bryan

    February 2, 2017 at 7:58 pm #444992
    robti
    Participant

    Bosch no fault codes displayed

    Hi my Exxcel 1400 express stopped turning on all programs but had no error codes coming up, so suspected either belt or brushes and found out brushed were well worn over 10 years old since new.

    So would you say it was the brushes or anything else I could try, just disappointed that I didn’t get an error code up to help

    February 2, 2017 at 8:43 pm #444993
    Martin
    Participant

    Re: Bosch no fault codes displayed

    You second thread on the same subject concludes that the carbons need replacing. As far as error codes are concerned though, many models of Bosch (even 10 year old vintage) do give error code indications. What you didn’t tell us was the all important model number (ENr number) shown inside the door and on the back panel.

    February 2, 2017 at 10:25 pm #444994
    robti
    Participant

    Re: Bosch no fault codes displayed

    WAE28464GB/03 FD 8603 600102
    Sorry I just wondered why no codes showed

    February 3, 2017 at 3:56 pm #444995
    Martin
    Participant

    Re: Bosch no fault codes displayed

    robti wrote:WAE28464GB/03 FD 8603 600102
    Sorry I just wondered why no codes showed

    If should have given an F:21 error code so, perhaps it needs more than just new brushes? The only way you’ll get the answer to that is when you change the brushes and it won’t work without carry out the ‘reset’ procedure.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.