Beko DW686 problem

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Beko DW686 problem

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 16, 2017 at 3:53 pm #92403
    skvsn
    Participant

    Hello all,

    we’ve got a problem with our Beko DW686 dishwasher. When I start a program it drains first, then fills some water and stops. After a few minutes it fills more water. Eventually after several filling cycles it overflows into the flood pan under the machine.

    What could be the problem? Is this related to a flow meter (how to check it?)?

    Thanks a lot for any help

    October 16, 2017 at 9:12 pm #451152
    skvsn
    Participant

    Re: Beko DW686 problem

    I tried to run a test program by holding Program and Start buttons and powering it up. It shows IFT on the screen but if I press Start button it doesn’t do anything – only arrow sign comes on. Am I doing anything wrong?

    Also checked flow meter and it seems to be fine. Checked wiring loom at the bottom edge of the door and can’t see any obvious damage to any of the wires.

    And finally after assembling everything back it now runs normal. Not sure if this is for long though

    October 31, 2017 at 1:26 pm #451153
    skvsn
    Participant

    Re: Beko DW686 problem

    well, it is not working again. It was washing all night, showing about 0:45 left in the middle of the night which changed to 1:11 when I opened it in the morning… Does this indicate main board failure?

    November 13, 2017 at 11:23 pm #451154
    skvsn
    Participant

    Re: Beko DW686 problem

    OK, I managed to enter into diagnostics mode finally. On this machine you only need to hold start button and then power up (no need to hold P button). After running diagnostic programs it leaked on P4 program and gave Er1 code. Anybody knows what this error code means?

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.