Hotpoint tdwsf83bepuk

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint tdwsf83bepuk

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 17, 2017 at 5:47 pm #92412
    robbo1973
    Participant

    hi all im going here on friday and tennants have advised its not starting and showing F01,any have the fault codes?

    cheers chris

    October 22, 2017 at 12:23 am #451213
    whitevanman
    Participant

    Re: Hotpoint tdwsf83bepuk

    could be motor fault unless they have changed the fault codes on newer models, motor triac pcb??

    October 22, 2017 at 9:53 am #451214
    iadom
    Moderator

    Re: Hotpoint tdwsf83bepuk

    These are Whirlpool based dryers so Hotpoint fault codes may not apply. 🙁


    THIS might help.

    Jim.

    October 25, 2017 at 7:15 am #451215
    robbo1973
    Participant

    Re: Hotpoint tdwsf83bepuk

    thanks for that, turns out its only 3 months old so under warranty but i managed to speak to a hotpoint engineer who confirmed the change heater as fluff build up but also change pcb as that goes faulty as well,i priced the bits up and probably would have been ber ! due to cost

    October 28, 2017 at 10:53 pm #451216
    Grendal
    Participant

    Re: Hotpoint tdwsf83bepuk

    Just for info F01 is heater relay on the board. Personally I always replace the board and heater as a pair as you tend to get an F06 recall if you just change the board hope this helps

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.