- This topic has 4 replies, 2 voices, and was last updated 8 years, 5 months ago by
.
-
Posts
-
Hi all!
We got an old washer dryer with fault code 3.
Cycle is starting and washing is finishing but second washing with softener didn’t happen last two times, just showing 3 and stop . I can override it by switch off and on again and after that can go to spin.
I don’t have manual and can’t find any info for that model, please give me an advice.
I have checked the fault codes for other Bosch washer dryer in forum but they don’t help me.
1. Is not the heater because last time washed on 90degrees and lid was as usual warm.
2. Is not the pump because is draining for less than 6mins.
Just after washing is not continue.
ThanksRe: Bosch wft 2800
It’s a water filling problem. So either the inlet valve is at fault or the water level air chamber is blocked with gunge.
Re: Bosch wft 2800
So don’t know how but just done full cycle without faults.
As suggested measure with multicet inlet valve- all four solenoids just unplug, measure and connect again nothing wrong found. Also check for gunge all holes were clear no blocking.
Hope will work without issues again.
Thanks for help!
- You must be logged in to reply to this topic.