- This topic has 4 replies, 2 voices, and was last updated 8 years, 5 months ago by
.
-
Posts
-
Hi any pointers appreciated.
Bosch dishwasher SRS43C12GB/21.
The dishwasher is overfilling.
No blockages and no flow meter on this. Micro switches are working on the overflow and pressure device.
Many thanks.Re: d/washer SRS43C12GB/21
Lower hose from metering system to sump blocked or restrictor in the diaphragm switch is blocked. The diaphragm is the microswitch with the blue goalpost actuating lever. Carefully prise the lugs around the edge of this unit and separate the two halves. The diaphragm will be seen; remove it. There is a small clear plastic restrictor set into the switch body. Mark its position and gently tease it out with a small blade. On inspection it resembles a tiny clear bowler hat. At the end (the rounded part) there is a small pin hole – push a pin through to clear it. Press back in place, refit diaphragm and clip the two halves together again, reassemble and test.
Also be aware this is one of the dishwashers recalled for the module change (fire risk)…… check for the blue ‘R’ sticker if it has been done or see if the FD is between 77 and 85 – but you knew that I’m sure! 😉
Hope that helps!!
Steve.
Re: d/washer SRS43C12GB/21
Thanks Steve.
I did clock it was a recall. When I activate the blue lever microswitch it will not turn the water off. Switch is OK so I was thinking must be PCB.
Thank you.Re: d/washer SRS43C12GB/21
rolf wrote:Thanks Steve.
I did clock it was a recall. When I activate the blue lever microswitch it will not turn the water off. Switch is OK so I was thinking must be PCB.
Thank you.Or door wiring?
Steve.
- You must be logged in to reply to this topic.