Non-starting JLWM1203

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Non-starting JLWM1203

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 15, 2017 at 1:06 am #92619
    myfil
    Participant

    I am repairing a John Lewis washer (Zanussi I guess) JLWM 1203 (PNC 914521851/01) that stops after a few seconds. The test pgm shows E31 plus 3 bleeps, and I assumed this is the pressure switch fault code (new electronic type). I have had success in the past just replacing the pressure switch. However in this case the replacement did not cure the fault.
    Does E31 represent any other fault? (On the test pgm the inlet valves and pump all work, but there is no motor action at all which puzzled me.)

    Regards
    Mike

    November 15, 2017 at 6:59 am #451735
    timdowning
    Participant

    Re: Non-starting JLWM1203

    I’m sure I’ve had a faulty heater cause this…

    November 16, 2017 at 7:26 pm #451736
    myfil
    Participant

    Re: Non-starting JLWM1203

    Thanks Tim
    I’m still wondering if its carbon brushes – after 5 years of use??
    Anyone found this?

    November 17, 2017 at 4:52 pm #451737
    Hollytree_Technical
    Participant

    Re: Non-starting JLWM1203

    Do an insulation test on the element because if they are low they can cause this form of fault.

    Jem

    November 17, 2017 at 5:39 pm #451738
    Martin
    Participant

    Re: Non-starting JLWM1203

    Can’t be that Jem as we all do a full insulation test before even attempting a repair. 😉

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.