Beko DW601 Not Filling

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Beko DW601 Not Filling

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 6, 2017 at 9:39 pm #92785
    Corner braces
    Participant

    I would appreciate some help with a Beko DW601 dishwasher that is not filling. It is a five year old dishwasher and at the weekend it stopped working. When I switch it on it is running through the drain cycle and then seems to get stuck. The motor makes noise, but the dishwasher does not fill or begin its cycle.
    I have manually filled it with water and it is pumping out. I have tested the water supply. The water supply is good and there is water getting to the valve. I then changed out the incoming solenoid valve, but it is still not working.
    I have run the Dishwasher functional test and it returned the “No incoming water detected or fill timeout” error.
    I would appreciate any advice on the where you think the fault could be or what my next troubleshooting steps are.
    Thanks

    December 7, 2017 at 6:36 pm #452191
    Seamy
    Participant

    Re: Beko DW601 Not Filling

    Likely the wires from water counter are broken in loom at bottom of door, they are the fine wires.

    December 7, 2017 at 6:41 pm #452192
    Corner braces
    Participant

    Re: Beko DW601 Not Filling

    Hi Seamy
    Thanks very much for your reply. That definitely sounds like something that could cause the issue.
    How would I identify the wires to the water counter?
    What does the water counter look like?
    D

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.