Panasonic NA-140VG4 undocumented error code?

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Panasonic NA-140VG4 undocumented error code?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 3, 2018 at 1:38 pm #93234
    polarity
    Participant

    Hi
    As above I have a Panasonic NA-140VG4 machine Producing an error at the end of a “Mixed” cycle of H44 that does not seem to be listed (I searched on here, checked the codes list,etc)
    It seems to get stuck at around 29-23 mins on a mix cycle not counting down further, sometimes starting all over again. Also it seems not to be taking the conditioner. Today when it was stuck I wiggled the selector knob slightly and that prompted it to run and I could hear it flush the conditioner from the drawer – it still produced the code at the end but it had taken the conditioner and appeared to finish the cycle normally (this could have been coincidence but I don’t think so as it had been at 29mins for about half an hour).

    Any help really appreciated, thanks!

    February 4, 2018 at 5:04 pm #453637
    BobHope
    Participant

    Re: Panasonic NA-140VG4 undocumented error code?

    Hi,

    your H44 Error code means the drum has not rotated up to the correct speed it is more than 100RPM slow, possible cause is drum bearing failure or something trapped between the inner and outer tub.

    bob.

    February 5, 2018 at 3:37 pm #453638
    polarity
    Participant

    Re: Panasonic NA-140VG4 undocumented error code?

    That’s great, thanks very much Bob. I’ll open it up (again – after the pipe came off the seal drain 6 months from new!) and take a look.

    Appreciate the help.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.