- This topic has 4 replies, 4 voices, and was last updated 8 years ago by
.
-
Posts
-
Hey guys, I have had a nightmare with this machine. I lay the machine on its back to replace carbon brushes and clean the pump as I have always done, when I plugged it in and started a wash the pcb blew while filling. A tiny amount of water had dripped onto the valve from the dispenser, I must have put thousands of machines down like this and never had this happen before. So I have fitted a new PCB which has switches which need to be set according to which machine but now it won’t fill on washes above 30 degrees. So I am guessing I have set a switch wrong can anyone help me out please? I suspect it is switch seven which I have set to off as there is no aqua stop or hot water inlet.
Thanks, DarrenRe: Bosch WFO2465GB/01
Set switch 7 to ON as it says “Standard or Aqua stop”. Macine is probably looking for a valve it doesn’t have.
Steve.
Re: Bosch WFO2465GB/01
Ive laid a machine down on its side and had fabric coditioner all over pcb before. Now I always check the drawer.
- You must be logged in to reply to this topic.