zanussi zdts102 overfilling

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi zdts102 overfilling

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • March 20, 2018 at 3:57 pm #93578
    funbobby
    Participant

    is there a common fault with the level sensor on these? pipes to and from where clean but still overfilling. thanks in advance

    March 20, 2018 at 4:32 pm #454860
    electrofix
    Moderator

    Re: zanussi zdts102 overfilling

    do you not get an i10 fault code

    i10 Water fill time-out

    (The pressure switch does not close on
    FULL after 90 sec. static fill, or never
    closes on “FULL” during the initial 60
    sec of the dynamic fill at 2800 rpm)

    Dave

    March 20, 2018 at 4:39 pm #454861
    funbobby
    Participant

    Re: zanussi zdts102 overfilling

    hi dave
    i ran it then then it started overflowing out of the drain hoses into the base after it had overfilled, no error code just triggered the base sensor and went into drain mode.

    March 20, 2018 at 4:58 pm #454862
    electrofix
    Moderator

    Re: zanussi zdts102 overfilling

    I take it that the valve closed immediately when you switched off, meaning its not a sticky valve problem

    Dave

    March 20, 2018 at 5:06 pm #454863
    funbobby
    Participant

    Re: zanussi zdts102 overfilling

    yes it stopped if i powered off.

    March 20, 2018 at 5:29 pm #454864
    electrofix
    Moderator

    Re: zanussi zdts102 overfilling

    I have pm’ed you one of the manuals at random. there are 16 dishwashers with the same model number

    Dave

    March 20, 2018 at 5:31 pm #454865
    funbobby
    Participant

    Re: zanussi zdts102 overfilling

    great thanks

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.