- This topic has 4 replies, 3 voices, and was last updated 8 years ago by
.
-
Posts
-
had this same issue once before.. basically customer has a bosch oven HBN9750GB/06 fiited hinges 2016 pt 267845 door not closing tight.. same thing happening again.. say they haven’t put any pressure on door etc.. previously i had same problem with another customer fitted 3 sets in bout 5 years tried inserts too made no difference.. any ideas?
Re: bosch hinges
well someone has put pressure on the door
if you take the hinges out. put them back in the oven (without the door). Release the lock and let it go all the way up. if its ok as far as I remember it will touch the oven casing. if it doesn’t its faulty
you can then try the hinge on the other side. if its a receiver problem you may get a different result. unless both sides are bentDave
Re: bosch hinges
not customer issue, its soft metal used in the production. The issue is the shoulder the roller rolls over which is what gives it that satisfying thump as the door closes the last bit, it wears rounded so new hinges will cure the fault but from day 1 it will start wearing again.
- You must be logged in to reply to this topic.