- This topic has 3 replies, 3 voices, and was last updated 7 years, 12 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
hi i see from web these dryers are not good,this one runs for a few minutes and flashes all lights checked heater ok suspect ntc or pcb any ideas please.richard. 🙁
Re: candy gov580c
More than likely pcb you can check resistance on front ntc from the pcb to confirm pcb fault
Re: candy gov580c
From memory I think that all lights flashing is an overheat fault caused by the relay on the PCB welding on, If it is then you will more than likely be able to see the glow of the element at the back of the drum when it stops (or measure the current draw of the appliance) to confirm.
Jem
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.