- This topic has 5 replies, 4 voices, and was last updated 7 years, 11 months ago by
.
-
Posts
-
Samsung Ecobubble washer. Model:- WF80F5E5U4W/EU. A0PC5ESF800731T.
Machine will fill, heat and wash. After about 20 mins the drum will jolt sporadically rather than turn smoothly. After a few minutes of this jolting the machine freezes and the timer countdown stops. Turn off and on again, water drains, refills and the jolting starts again. Left the machine for ten minutes switched off, started a new program and back to normal…. for a while. No fault codes displayed.
I am pretty sure it’s the main PCB but any suggestions welcome. I know that some Samsung Ecobubble machines carry a five year warranty (and ten year motor g’ntee); is this one of them?Thanks!!
Steve.
Re: Samsung Ecobubble washer stops halfway thro’ program.
Had quite a few of these, it’s always been the module!
Re: Samsung Ecobubble washer stops halfway thro’ program.
Is this the PCB? 5045382360293 on Connect.
Thanks again!
Steve.
Re: Samsung Ecobubble washer stops halfway thro’ program.
Looks the same as the ones I’ve fitted.
It’s worth haggling a bit with the price too…I have a job that described similar as yours except at the end of the cycle. Owner says it was stuck at one minute and the motor jolted as if it was stuck and attempted to shift. I attempted to resolve this by calibration which worked for couple of cycles then it played up.
I’ve seen this on Beko washers and found that motor pcb module was to blame.
am I correct in thinking that it’s the main pcb module not the fascia pcb module?
- You must be logged in to reply to this topic.