- This topic has 3 replies, 3 voices, and was last updated 7 years, 9 months ago by
.
-
Posts
-
good evening,
called to attend to this warning light.
dis the following
1. condenser clear
2.filters all clear.
3. fan impellor de-fluffed to push air better.
4. cleaned out water pump housing
5. put in damp towels and it runs perfectly for 20 minutes heating drying pumping water. then all of a sudden it stops with clean out airways light lit.6. press start and away she goes for another 20 minutes and same again.
please any ideas.
thanks
keithRe: miele cond dryer T8822c "clean out airways" after 20 m
Worked on an t8442c recently, dif fault. But might be worthchecking the thread (week or two old) as i posted the thermal sensor reading charts. Temp/kOhms.
Possibly one of these reading too hot, thus machine thinks its airways are blocked?
There are some links to various manulas of similar machines tbere too.
Gl
Re: miele cond dryer T8822c "clean out airways" after 20 m
If the condenser I’d fully clear, the front duct filter s can be clogged and need hot wate4 and a nylon brush,of sorts.
That’s where I would be looking at.Re: miele cond dryer T8822c "clean out airways" after 20 m
Thanks for that.
I have thoroughly cleaned everything. Including fan impeller blades.
I haven’t been back yet.
My next move is to reprogram the drying cycle to be more tolerant.
Also I’ll tske readings on sensors as suggested although I don’t think they are faulty as it will happily run another 20 mins immediately after it initially stops.
I will report back if I get it running longer.
K
- You must be logged in to reply to this topic.