- This topic has 4 replies, 2 voices, and was last updated 7 years, 8 months ago by
.
-
Posts
-
HI Guys,
iv been out to see this machine for a quick inspection..
dead machine, checked mains input and power going past filter ok
customer said it tripped before stopping working, i did not investigate the tripping on last visit so im presuming something has blown the board?
so its not tripping now but dead board by sounds of it.
does this sound familiar? im going to do an insulation test next visit but has to be repaired at all costs with cost of pcb boards bit worried about the tripping..
Simon
Re: Hotpoint WDAL9640G uk ?
if its boards then they will need to be programmed. that means if you have not got one you would need to buy s programmer and the software for the board as well
is it not covered by a 5 year parts warranty? would be a lot cheaper for the customer and easier for you
Dave
have pm;ed you the manual
Re: Hotpoint WDAL9640G uk ?
Thanks dave for reminding me of the programming as i was about to order a new board!
i think i will ring tony at emw and hope i get lucky…..
apart from that im stumped, iv seen one on ebay but the numbers dont match from the board sticker…… model number the same but not the serial….
Simon
Re: Hotpoint WDAL9640G uk ?
you could buy a new board and get EMW to programme it. have done that once or twice
even get a second hand board and get tony to change software or check its correct
Dave
Re: Hotpoint WDAL9640G uk ?
:eeek:
Thanks for info, replaced board that was programmed for that model and its still dead, iv been right through machine this time, removed facia no signs of blown tracks or burning? my gut says its the facia board? iv had my meter over the mains input and its fine, all wiring looks intact…
Simonb
- You must be logged in to reply to this topic.