Zanussi Lindo300 washer – UK Whitegoods

This topic has 11 replies, 3 voices, and was last updated 7 years, 5 months ago by wilf.

Viewing 12 posts - 1 through 12 (of 12 total)

Author

Posts
October 23, 2018 at 12:55 pm #94896

wilf
Participant

ZWF91483w 914910415 02 Machine runs program perfectly until 9 mins then stops with start flashing, pressing any button does nothing, switch off and reset to spin to finish (pump runs ok) There is no blockages I can see I suspect the board at the top or am I missing something? Is this board configured ? Any ideas anyone ?

Thanks Wilf

October 23, 2018 at 11:32 pm #458678

electrofix
Moderator

have you gone into engineering mode and checked for fault codes

Dave

October 24, 2018 at 9:35 am #458679

wilf
Participant

how do you get into engineering mode?

wilf

October 24, 2018 at 3:00 pm #458680

electrofix
Moderator

send me your email add will find you some reading

Dave

October 24, 2018 at 3:08 pm #458681

wilf
Participant

thanks Dave but your message box is full

wilf

October 24, 2018 at 3:11 pm #458682

electrofix
Moderator

give me 5 its all the old messages that came back after the forum changeover

Dave

October 24, 2018 at 3:22 pm #458683

electrofix
Moderator

8 pages of messages removed some as far back as 2013

try again

Dave

October 26, 2018 at 6:53 am #458684

wilf
Participant

Dave, your message box is still full.

wilf

November 5, 2018 at 8:16 am #458685

wilf
Participant

Dave would be grateful if you could try again to send me that info.

Regards wilf

November 5, 2018 at 9:59 am #458686

electrofix
Moderator

not a problem m*

try sending me your email address again

Dave

November 11, 2018 at 8:49 pm #458687

HotDog
Participant

could i have same info

November 11, 2018 at 10:32 pm #458688

electrofix
Moderator

no probs but need an email add

Dave
Author

Posts

Viewing 12 posts - 1 through 12 (of 12 total)

You must be logged in to reply to this topic.