Bosch dishwasher SMV40C30GB/36 FD9510

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch dishwasher SMV40C30GB/36 FD9510

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • March 8, 2019 at 12:41 pm #95572
    kevinlewis
    Participant

    It fills and pumps out okay. The spray arm turn. doesn’t seem to be heating. The tap light illuminates . No water is leaking into the base. Any ideas?

    March 8, 2019 at 12:57 pm #460778
    electrofix
    Moderator

    assume you have checked heater for contiuity

    with water light have you checked reed sw pt no 00611317 or you can just solder in a new reed sw rs part no 362-2495

    am thinking if it thinks its not full it may not heat

    Dave

    March 10, 2019 at 2:03 pm #460779
    kevinlewis
    Participant

    Thanks Dave. I took the integrated door and bottom plynth off but did not remove it from the housing to get to the heater. I didn’t want to remove the machine until i had ran this fault past yourselves in case it was a common pcb fault. Thanks again.

    March 16, 2019 at 5:17 pm #460780
    kevinlewis
    Participant

    Can you top up these models with a couple of litres of water or does it need to enter via the flow meter where the water enters.

    March 16, 2019 at 5:31 pm #460781
    electrofix
    Moderator

    the reed switch counts the water as it enters, acts like a water meter does for your house. so unless it comes through the sw it cant be registered by the computer. ( there is no pressure sw)

    so to answer your question no you cant add water and expect it to work

    Dave

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.