AEG TD inverter

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › AEG TD inverter

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 14, 2019 at 12:04 pm #95602
    electrofix
    Moderator

    Long Shot

    went to an AEG condenser TD model T86280 IC pnc 916096791 / 01

    found fault of blown inverter board

    on closer inspection the charge / safety resistor has blown so badly its gone

    if anyone goes to one in the near future or has one they can open to find the value of R1 I would be grateful


    Dave

    March 15, 2019 at 12:57 pm #460863
    baron
    Participant

    Don’t worry what resistor you put there (10 to 47 ohms) but verify power switching LNK and diodes even diodebridge.

    March 15, 2019 at 1:22 pm #460864
    electrofix
    Moderator

    yes was going to guess around 47 ohms or so and change chip but thought I would see if anyone knew correct one.

    after all resistor is only there to lower cap inflow current on switch on

    Dave

    March 16, 2019 at 5:44 pm #460865
    baron
    Participant

    electrofix wrote:after all resistor is only there to lower cap inflow current on switch on
    Dave

    A little more than that. You can say that he works like a current limiter (fuse) or RLC filter and so on…

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.