F-10 Error code on an Indesit Wixe127UKTEV Washer

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › F-10 Error code on an Indesit Wixe127UKTEV Washer

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 18, 2019 at 8:17 am #95620
    Mariner
    Participant

    Hi, So I’ve got a F-10 error code as the washer starts to fill, I’ve checked the pipework to the pressure switch is clear and the pressure switch itself is working ok. I have checked the heating element and the temperature sensor both are working correctly. If I leave the sensor disconnected the washer goes further through it’s cycle until I get the F-03 error code (open circuit on the temp sensor). Could it be the control board or has anybody got any other suggestions ?
    Thanks

    March 18, 2019 at 9:36 am #460890
    electrofix
    Moderator

    there is a tech bulletin against this model for the pressure tube rubbing through

    Dave

    March 18, 2019 at 10:50 am #460891
    Mariner
    Participant

    Thanks for your reply Dave I have checked the tube and there are no holes in it

    March 18, 2019 at 11:18 am #460892
    electrofix
    Moderator

    well in that case its prob either the pressure sw or the board

    if you have not done it already trace the pressure sw wires to the main board and remove and replace the plus 2 or 3 times to make sure contacts are clean

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.