Beko DFN1000x

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Beko DFN1000x

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • June 21, 2019 at 5:09 am #96034
    polcat81
    Participant

    Hi,
    My dishwasher stopped heating water, replaced through flow heater and thermostate, washed once heat OK, stopped after that. Any clues what else should be replaced?? Any idea how to retrieve any foult codes as this is one swith only operation.

    June 21, 2019 at 8:26 am #462123
    electrofix
    Moderator

    think you may have mistyped the model as I cant find it

    I would recheck the new heater first to check its not blown

    Dave

    June 21, 2019 at 10:37 am #462124
    polcat81
    Participant

    Hi Dave,
    Yep my bad, Dfn1000x, heater was brand new, it has washed with hot water and then next wash cold again.

    June 21, 2019 at 11:02 am #462125
    electrofix
    Moderator

    which could be 2 things

    1 the heater has blown again ( we have to find out why)

    2 the timer is not turning it on

    3 broken wire

    we have to eliminate the heater first so you would need to measure its resistance from the terminals

    Dave

    June 22, 2019 at 8:37 am #462126
    polcat81
    Participant

    What could be a reason for heater blowing up, and how to check it.
    Thank you

    June 22, 2019 at 8:44 am #462127
    electrofix
    Moderator

    you need a multimeter on the ohms scale and you would expect a reading under 100 ohms if its ok. take the wires off the heater and measure between the terminals
    if its blown then its either
    A fault which is rare
    B the heater is coming on with no water in it which is a timer problem

    Dave

    June 25, 2019 at 12:54 pm #462128
    polcat81
    Participant

    Thanks Dave, hot to change timer, is it software issue or hardware?? I am going to check that tomorrow.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.