hotpoint wma 40

Home › Forums › General Trade Forum › hotpoint wma 40

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • May 16, 2005 at 10:32 pm #9622
    pup
    Participant

    plesae help wegot hotpont wma40 fault is after switch on all lights start to flash

    May 16, 2005 at 10:50 pm #134918
    kwatt
    Keymaster

    Is it all the lights or is there a sequence to it?

    K.

    May 17, 2005 at 4:42 pm #134919
    pup
    Participant

    Is it all the lights or is there a sequence to it?

    K.

    all lights flashing

    May 17, 2005 at 11:12 pm #134920
    kwatt
    Keymaster

    Any ideas guys?

    K.

    May 18, 2005 at 7:35 am #134921
    Dave_Conway
    Participant

    Re: hotpoint wma 40

    It’s a bit odd that all the lights flash to be honest so one would suspect the control unit to be at fault.

    Try holding the on/off and start buttons in simultaniously for a few seconds to see if it resets, if that fails, then it’ll be best to call an engineer to diagnose for you.

    Repairs@ and/or the directories should be able to provide the info for you if required.

    Dave.

    May 18, 2005 at 8:49 am #134922
    iadom
    Moderator

    Re: hotpoint wma 40

    There is no on/off button on WMA40, only a start button. You do need a visit from an engineer.

    May 18, 2005 at 9:48 am #134923
    pup
    Participant

    Re: hotpoint wma 40

    iadom wrote:There is no on/off button on WMA40, only a start button. You do need a visit from an engineer.

    thanks guys time to enineer

    June 26, 2005 at 7:49 pm #134924
    pup
    Participant

    who does sw19

    does any one cover sw19 i hve a job f/f sent to me by mistake from ukw reapairs

    June 26, 2005 at 9:52 pm #134925
    Dave_Conway
    Participant

    Re: who does sw19

    pup wrote:does any one cover sw19 i hve a job f/f sent to me by mistake from ukw reapairs

    Yep, Electralife do, I just checked 😀

    If the customer goes back to repairs@ they will get them.

    How did it come to you by mistake pup, customer putting the wrong info in ?

    Cheers.

    Dave.

    January 24, 2006 at 7:23 pm #134926
    pup
    Participant

    Re: hotpoint wma 40

    iadom wrote:There is no on/off button on WMA40, only a start button. You do need a visit from an engineer.

    January 24, 2006 at 7:36 pm #134927
    Martin
    Participant

    Re: hotpoint wma 40

    If you’re in the trade pup, there is really no need to post trade questions in the public forums (as this thread was!)

  • Author
    Posts
Viewing 11 posts - 1 through 11 (of 11 total)
  • You must be logged in to reply to this topic.