Beko WDR7543121W probs with new PCB

This topic has 5 replies, 2 voices, and was last updated 6 years, 7 months ago by simtoms.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
September 3, 2019 at 8:23 am #96342

simtoms
Participant

Hi folks,

I fitted a new main PCB (black case, lower RHS looking from rear), to resolve a dead fault inc display. I now have full display function back, except for when I hit start it’s a double beep as if I’m selecting an unavailable option. There’s also no flashing light next to the start button.
Am I missing something silly?!
Machine is Beko WDR7543121W. Product. 7161541500
Thanks, SImon

September 3, 2019 at 9:02 am #463084

electrofix
Moderator

first check you have fitted correct part. I got part no 2437301081

then

if ok cant send you the tech if you need it. just need an email add

Dave

September 3, 2019 at 2:08 pm #463085

simtoms
Participant

Thanks for quick response Dave,

according to C.nn.ct..ns part number 2437301080 should be right but it does feel as though it’s the wrong board by the fault.
If your info tells you otherwise I’ll try and send this one back and go with your part number.

Kind regards

Simon

September 3, 2019 at 7:21 pm #463086

electrofix
Moderator

the part number you have is listed by beko but does not list any machines its fitted too. my part number does list models
pic shows all board associated with your prod code

Dave

September 5, 2019 at 12:46 pm #463087

simtoms
Participant

Well you were bang on Dave, because I ordered the part number you supplied and hey presto!
I’m not going mad after all. Perhaps.
Thanks again.
SImon

September 5, 2019 at 2:23 pm #463088

electrofix
Moderator

one of the biggest problems in this game is accurate accessible info and this is a case in point. without this information you could have been tearing your hair out for days

happy to help anytime

Dave
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.