Beko Dw686 Over filling?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko Dw686 Over filling?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 23, 2019 at 6:32 pm #96433
    ray.t
    Participant

    I have been to this dishwasher again today as it’s flooded its base for the second time in two weeks. I have emptied the base and watched it run and can’t see any leaks. The customer did mention that she had seen some water on the floor in front of the machine.
    The only thing I can see that is a bit strange is that there seems to be a lot of water in the machine. When it’s on a cycle it fills to just below the spray arm. Does anyone know if that’s normal for this model? I’m thinking of maybe trying a new flow meter.

    Thanks,
    Ray

    September 23, 2019 at 8:15 pm #463367
    electrofix
    Moderator

    if the paddle starts to touch the water in any model its too high

    beware there seems to be 2 flow meters. might be easier to solder in a new reed sw

    switch changes from 14/11/16

    Dave

    September 24, 2019 at 5:29 am #463368
    ray.t
    Participant

    Thanks Dave

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.