Electrolux ESL6370RO (91143501405) 4 beep error

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Electrolux ESL6370RO (91143501405) 4 beep error

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • October 3, 2019 at 9:02 pm #96483
    kieran78
    Participant

    Hi all,

    I’m getting 4 beeps from my Electrolux ESL6370RO (91143501405) dishwasher. It sometimes fails to drain properly, but even when it does drain properly, the pump sounds like it is trying to suck out water that is not there. From what I’ve read, sounds like maybe a pressure sensor/switch issue?

    The outflow pipe and sink trap all seen clear and when I can convince it to drain, it drains ok, but it just doesn’t seem to be trying to do it at the right time.

    Any thoughts?

    October 4, 2019 at 12:29 am #463543
    electrofix
    Moderator

    yes 4 flashes comes up as a pressure sensor error
    problem with these fault is you cant tell if it the sensor or board that’s fault till you replace one or other of the components

    sensor
    https://shop.electrolux.co.uk/dishwashers/dishwashers/electronics/dishwasher-analogic-pressure-switch/p/1174745107

    first I would remove it and check the tube for debris and the electrical connection both at the switch and the board (warning do not blow into the sensor !!)

    Dave

    October 4, 2019 at 8:16 am #463544
    kwatt
    Keymaster

    Or, this cheaper compatible one:

    https://shop.ukwhitegoods.co.uk/h264437as-compatible-pressure-sensor

    😉

    K.

    October 4, 2019 at 10:06 am #463545
    kieran78
    Participant

    Thanks for your quick responses both of you. I’m reasonably DIY capable, so happy to give this a go, but are there any diagrams or fitting guides for these things anywhere? I’ve not opened up the dishwasher yet so it might be obvious what part this is, but if it isn’t, a bit of guidance would be great!

    Thanks,
    Kieran

    October 4, 2019 at 12:16 pm #463546
    electrofix
    Moderator

    unit is easy to find at front right hand side. take lower cover off and you will see the tubes going to it

    Dave

    October 13, 2019 at 3:54 pm #463547
    kieran78
    Participant

    Been busy this week so only just had a chance to look at this again.

    I can’t find anything that really looks like that piece at the front of the machine so I fear my machine might be one where you need to go in at the side perhaps?

    This is a photo of the front panel of the machine: https://photos.app.goo.gl/juMPPn9fp2F6qdGc9

    October 13, 2019 at 4:12 pm #463548
    electrofix
    Moderator

    follow this tube
    if this tube is blocked it causes your problem

    Dave

    July 4, 2020 at 6:29 pm #463549
    Richardparker1974
    Participant

    kieran78 wrote:Thanks for your quick responses both of you. I’m reasonably DIY capable, so happy to give this a go, but are there any diagrams or fitting guides for these things anywhere? I’ve not opened up the dishwasher yet so it might be obvious what part this is, but if it isn’t, a bit of guidance would be great!

    Thanks,
    Kieran

    hi , Did you Get it working ?

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.