Hobart Commercial Dishwashers

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hobart Commercial Dishwashers

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 18, 2005 at 7:50 pm #9664
    euro
    Participant

    Would anyone be able to help out with a wiring diagram for a Hobart FX20 dishwasher. Replaced the old timer with new PCB version, followed the fitting instructions but machine wont work.

    Many Thanks

    Andy

    May 20, 2005 at 11:58 am #135141
    bassman
    Participant

    Re: Hobart Commercial Dishwashers

    Hi Andy I may be able to get one for you do you need the old one with old timer or new one with module conversion.
    Ray

    February 16, 2006 at 1:18 am #135142
    welsh__boy
    Participant

    Re: Hobart Commercial Dishwashers

    I know this is too late to help, but may be a use to somebody else. A lot of people forget to fit the jumper from the selector switch to the PCB, and quite a few don’t set the dip switches to the correct settings. One thing to remember with most Hobarts, esp. the FX range is that they need to heat up the rinse tank before they’ll do anything. It won’t fill, wash, nothing until that rinse water is hot. So if the element is knackered, or the stat is staying closed the machine will do nothing, only that little light at the top, if it still works!!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.