Hotpoint TDWSF 83B EP not sensing

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › Hotpoint TDWSF 83B EP not sensing

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 16, 2019 at 12:24 pm #96742
    Dave Walters
    Participant

    Hi, I have a Hotpoint TDWSF 83B EP Condenser Tumble dryer. A few days ago I had to rescue a bra underwire from behind the drum, which meant taking the top off. Since then it won’t dry properly on the usual settings.

    When I start the dryer programme, it detects how long it will need e.g 1hr 30 mins, but after 5 – 10 mins this drops to 3 minutes and the cycle stops, with the clothes still wet.

    The unit is heating up. I’ve checked the pipes to the water tank and they’re attached and not blocked (water is being collected). At the end of the cycle there are no errors displayed.

    Any ideas?

    November 16, 2019 at 12:41 pm #464660
    Specialist01269
    Participant

    First thing to do would be to turn the power off & remove the top again, then carefully check that you haven’t dislodged or broken any wires. A good bright torch often helps.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.