zanussi front panels

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › zanussi front panels

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • May 19, 2005 at 7:53 pm #9683
    admin
    Keymaster

    Hi, the push button on the front of my zanussi for the “normal” wash has been pressed so many times that it remains depressed. It is not affecting performance but for aesthetic reasons, can it be fixed? If so is it an easy and/or cheap diy job or does someone have to be called in? Thanks.

    May 19, 2005 at 11:39 pm #135226
    Penguin45
    Participant

    Re: zanussi front panels

    It’s usually a snap fit into the panel, but we will not be able to advise further without the model number…………….

    Regards,
    Penguin45.

    May 22, 2005 at 9:29 am #135227
    stephen66
    Participant

    Re: zanussi front panels

    Penguin45 wrote:It’s usually a snap fit into the panel, but we will not be able to advise further without the model number…………….

    Regards,
    Penguin45.

    Hi, sorry for the oversight; it is the de6965. Thanks.

    May 22, 2005 at 5:28 pm #135228
    Penguin45
    Participant

    Re: zanussi front panels

    If you are lucky, the switch will have slipped out of the clips and can be snapped back into place. If you are unlucky the lugs will have broken and the console panel will need replacing.

    P/no is 1525744-81/7 – £55.88 😯 – plus VAT etc.

    Power off before further investigations.

    Regards,
    Penguin45.

    May 22, 2005 at 6:12 pm #135229
    stephen66
    Participant

    Re: zanussi front panels

    Penguin45 wrote:If you are lucky, the switch will have slipped out of the clips and can be snapped back into place. If you are unlucky the lugs will have broken and the console panel will need replacing.

    Thanks. Like I said, it is cosmetic only; it still works, so it’s a job that can wait till a rainy day; there’s no rush. Is it easy to take the front off? Thanks,

    May 22, 2005 at 7:00 pm #135230
    farmboy
    Participant

    Re: zanussi front panels

    You might find that the main board is the problem – it has little sprung plastic bits which the selector buttons press against and these can snap. If it’s just a cosmetic issue then i would just put up with it.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.