- This topic has 1 reply, 2 voices, and was last updated 6 years, 4 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Help please if you can.
Working on this Beko DW. (for too long at this stage but!)
The display lights up but nothing else happens.
I can do a reset to cancel the program – the display goes to “1” a further press on the start button brings up “END”. Then by powering OFF & ON again, I can select a program but after pressing START nothing further happens.
I get ER9 when I try to enter diagnostics but nothing else happens. Sometimes IFt is displayed. I am not sure if I am doing it correctly.
I did find two broken wires where the door hinges, but repairing them has made no difference.
By adding water to the dw with a jug at one stage the circulation pump ran.
Any help or suggestions welcome.
Thanks in advance.
Tom
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.