Hotpoint f10 fault heating element has Continuity

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Hotpoint f10 fault heating element has Continuity

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 19, 2020 at 5:29 pm #97068
    Dickyboy07
    Participant

    Hi please help I have a hotpoint Aquarius fdl570p.r and six months ago it would stop working mid cycle and l2 and l4 would start to flash after a bit of online research I found it was an f10 fault which said it was the heater element ,so after Checking the heater element I found it had no continuity across the element so I replaced it .all was fine until last week , it is now again stopping mid cycle and l2 and l4 are flashing again so I checked the new heater element for continuity across it , it seems fine now I’m at a loss at what I should do next
    and help would be greatly appreciated please thank you
    regards Richard

    January 19, 2020 at 6:19 pm #465982
    electrofix
    Moderator

    I would check the wiring back to the board and then relay on the board that controls the heater. look of bad joints on the pcb around the relay legs

    Dave

    January 19, 2020 at 7:30 pm #465983
    Dickyboy07
    Participant

    Thankyou I will try that

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.