Samsung washer filling

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Samsung washer filling

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 2, 2020 at 12:05 pm #97133
    zadokkodaz
    Participant

    Hello y’all.

    I have a front loader washer that fills through fill hose at the end of a wash. It only stops once I cut the power. Would I be correct in thinking an issue with the board? Or filling valve?

    February 2, 2020 at 1:32 pm #466253
    electrofix
    Moderator

    if it was the valve it would do it all the time so it must have to be energised by the board

    has this been working ok till now and just gone wrong ?

    is it definitely connected to cold water and not hot ? ( had this fault on a beko that filled with water after spin because things were too hot )

    Dave

    February 2, 2020 at 5:16 pm #466254
    zadokkodaz
    Participant

    Thanks Dave, it was working completely fine until a few days ago. So leaning towards new board, we think? It’s weird, if the power isn’t cut immediately after the cycle, it automatically wants to fill cold water again. Yes it’s definitely connected to a cold feed.

    February 2, 2020 at 5:30 pm #466255
    electrofix
    Moderator

    what does it do then

    fill then stop
    or
    restart another programme ?

    Dave

    February 2, 2020 at 6:47 pm #466256
    zadokkodaz
    Participant

    That I don’t know. Plays the end of cycle noise then is switched off asap.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.