- This topic has 5 replies, 3 voices, and was last updated 6 years, 1 month ago by
.
-
Posts
-
Thank you all for your time and assistance!
I found the following link:
https://www.ukwhitegoods.co.uk/help/fault-codes/laundry-fault-codes/3323-indesit-widl-washer-dryer-fault-codesand it appears as though it is an F15 fault (all lights flashing), but the above link doesn’t appear to show the vertical side lights – of which the Bottom red lock light, the second from the last green (dry) light and the middle green (rinse) light are all constantly on while the error code is flashing.
Additionally, its only an intermittent issue. Would it not be a constant error if there is a faulty wire?
If anyone has any additional information, or could clarify that would be fantastic!!
The link you posted is not for your machine. This link to a similar Hotpoint machine is what you need, ignore all of the flashing lights. The error code is given by reading the right hand vertical lights from BOTTOM to TOP with the bottom light being No:1. They are shown horizontally in the link to save space. 😉
https://www.ukwhitegoods.co.uk/help/…wd-fault-codesOr give us the positional numbers of the steady lights from BOTTOM to TOP.
F13= Dryer ntc open or short circuit fault.
Check efficiency of contacts on connector J011 (commutator) or
J14 (three-phase) on PCB;
– Check NTC impedance value on wiring connectors J011
(commutator) or J14 (three-phase) between pin 1 and pin 2.
The impedance value at ambient temperature (20°C) must be
approximately 20 KOhm;
– If measurement is incorrect check NTC wiring;
– Check the same parameter directly on the NTC (20 KOhm);
– Renew NTC;
– Renew PCB.I have an Indesit XWC61452. All lights flashing apart from: 1st four wash cycle progress lights, which are off off on on. which error code link should I use? [video=youtube_share;TpOkJEUHAz8]https://youtu.be/TpOkJEUHAz8[/video]
- You must be logged in to reply to this topic.