Hoover GOC 580C Stopping

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover GOC 580C Stopping

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 20, 2020 at 9:58 am #97232
    delta01
    Participant

    hi this dryer stops after a few minutes we recently replaced the start cap could the motor be overheating any help appreciated thanks john

    February 20, 2020 at 7:30 pm #466615
    kaibart
    Moderator

    Motor will not be over heating more likely cause are either heating element or front ntc if these as ok or will be a pcb

    February 21, 2020 at 1:01 pm #466616
    Hollytree_Technical
    Participant

    I have seen a few of these where the control relay for the element has burnt out internally leaving the heater permanently on (with an empty drum you can usually see an orange glow inside at the back if this is the case), it does tend to flash all lights if this is the fault.

    Jem

    February 24, 2020 at 2:55 pm #466617
    delta01
    Participant

    Thanks guys will check it ouit

    February 26, 2020 at 9:17 am #466618
    delta01
    Participant

    hi yes it was the relay well burnt out we replaced it sorted thanks again John

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.